| The BRE is an electronic version of the
BR1 and is a "drop in" replacement for the BR1. The part number is the
same except that BR1 is replaced with BRE. The BRE has passed the same tests with
UL, CSA, and FM.
BRE enclosed construction with front
facing dial and knob. The BRE timer has a heavy duty terminal
block, with 9 screw terminals that will readily accept 16 gauge
wire commonly used in industrial circuit wiring.
The case of the BR series reset timer
is injection molded Lexan. This material is recognized by
Underwriters Laboratories for use as the sole support of current
carrying components. Lexan is self extinguishing, has a high
impact strength, and high dimensional stability.
Operation:
The NEW BRE series reset timers are
micro processor driven. They provide an accurate adjustable time
delay between the actuation of the control circuit and the
operation of the load switches. New standard pilot light is on
during timing period. Times through a preset cycle and is then
automatically or manually reset until it is restarted by an
outside source.
| Repeatability: |
Typical
± 3/4% of full scale |
| Reset
Time: |
200
ms |
| Voltage/Frequency: |
120V
(+10, -15%), 50/60 Hz
240V (+10, -15%), 50/60 Hz |
| Burden: |
Motor
- 3 Watts
Clutch - 4 VA |
| Output
Rating: |
10
Amp - 1/4 HP, 120/240 VAC
1/2 Amp - 125 VDC
1/4 Amp - 240 VDC |
| Power
On Response: |
30
ms Clutch Pull In
4 ms Drop Out |
| Dial
Setting Accuracy: |
2%
of Full Scale |
| Minimum
Setting: |
3%
of Full Scale |
| Operating
Temperature: |
-10°
to 140° F (-23° to 60° C) |
| Laboratory
Testing: |
U.L.
Recognition E61735
C.S.A. Certification LR-27967
F.M. Approved 21038 |
Conversion
Chart From BR1 to BRE Buy
Online At www.industrialcontrolonline.com
|
